Shopping Cart
T-VER-971BP-200 Split-Core Bi-Polar DC Transducer
Split-Core Bi-Polar DC Transducer sensor that measures up to 200 Amps of DC current in both flow directions.
Requires analog port selection during U30 system configuration and use of a S-FS-CVIA when using the H22-001 logger. When using a U12 logger, this sensor requires a 4-20mA input cable (CABLE-4-20mA) and external power provided by an AC adapter (AC-SENS-1).
Note: For measurements larger than 120A the device must be powered by a minimum of 15V to maintain expected accuracy.
- Measures current flow in both directions which is especially beneficial for Solar PV applications.
- Adjustable span range
- Small size, split-core for ease of installation
Environment:
The T-VER-971BP-200 Sensor is for use in Indoor environments
Measurements:
The T-VER-971BP-200 Sensor supports the following measurements: DC Current
| DC Amperage (bi-polar) |
| Measurement range: +/- 2 to +/- 200 (via span adjust) |
| Accuracy (below 100A span): +/- .5 A |
| Accuracy (above 100A span): +/- .5% full scale |
| Sensor supply: 12 - 24 DC (15 VDC min. for currents > 120 A), 35 mA no-load to 110 mA at 200 A current |
| Isolation: 600 VAC rms |
| Operating temperature range: -30 to 60C (-22 to 140F) |
| Humidity range: 10 - 90% non-condensing |
| Response time: 2 sec. |
| Output: (bi-polar) 4 - 20mA |
| Dimensions: 3.1x2.8x1.4 in. (79x70x36 mm) |
| Weight: 5.25 oz. |
| Sensor opening: 1.1x.9 in. (28x23 mm) |
| LED indications: single green blink=Norm, double green=Over Span, red+green=Over Limit, solid red=overload |
| CE, UL |
S-FS-CVIA For use with HOBO H22-001
Cable-4-20mA for use with HOBO U12-006/008 & UX120-006M (requires AC-SENS-1)
You might also like
Viewed products
ELECTRICITY NETWORK ANALYZERS
UPM3100 LCD Power Meter (DIN 144x144)
16 other products in the same category:
INSIDE & OUTSIDE USE
COUPLER2-A Couplers for HOBO Data Loggers with Shuttle U-DTW-1 and Base Station-U4
Tap to zoom
