TP876 Delta-Ohm Globe thermometer

Name: TP876 Delta-Ohm Globe thermometer
Brand: SENSECA (Delta Ohm)
SKU: TP4876

Reference: TP4876 - Manufacturer: SENSECA (Delta Ohm)

TP876: Globe thermometer Ø 50 mm with handle. Cable 2 meters long.

TP876:
°C máx: -30 +120
Response Time: 15s

Manual: HD2307.0 Globe thermometer

INSIDE & OUTSIDE USE

HD2307.0 THERMOMETER for sensors Pt100/1000

SENSECA (Delta Ohm)

HD2307.0

View

HD2307.0 THERMOMETER for sensors Pt100/1000

SENSECA (Delta Ohm)

HD2307.0

View

Viewed products

AUTOCLAVES

LHA-D1 Series Horizontal Laboratory Top Loading Autoclaves (139 °C)

LABTRON

LHA-D1

LHA-D1 Series Horizontal Laboratory Autoclaves are Microprocessor controlled automatic autoclaves with vacuum drying function.

View

SENSORS & PROBES

TP472I.10 Immersion Sensor Probe

SENSECA (Delta Ohm)

TP472I.10

View

TPD0 Sensor of Temperature for Indoor

Veris

TPD0

View

SENSORS & PROBES

ML3-Kit ThetaKit (Soil Moisture Measurement Kit and Temperature)

Delta T

ML3-KIT

€1,720.00

Soil Moisture Measurement Kit from Delta-T ML3-KIT ThetaKit

Rain

Heated Rain Detector sensor (SPP)

Nesa srl

SPP

€185.00

16 other products in the same category:

SENSORS & PROBES

MGT-0420-001 CURRENT TRANSDUCER 4-20 mA

Magnelab

MGT-0420-001

View

SENSORS & PROBES

SI-411 SDI-12 Digital Output Standard Field of View Infrared Radiometer

Apogee Instruments

SI-411

€1,045.00

SDI-12 Digital Output Standard Field of View Infrared Radiometer "

CT-2VA Electrocorder Power Logger and Energy Logger for Industry and Light Commercial

FOR ENERGY & ELECTRICITY

CT-2VA Electrocorder Power Logger and Energy Logger for Industry and Light Commercial

Acksen

CT-2VA

€630.00

One voltage channel 300VacTwo models available, 60Aac or 400Aac range.Complete with Electrosoft energy analysis softwareSealed to IP65/NEMA 12/4 as standard The CT-2VA is a single-phase voltage and current data logger that uses a clip-on CT (current transformer) and plug to connect to the mains supply / equipment you wish to monitor. Setup the Logger...

View

CO2 Carbon Dioxide

AO-CO2-U/A CO2 Air Quality Sensor for In-wall Mounting Indoor

AO-Electronics

AO-CO2-U/A

€310.00

CO2: 0-2000 ppm Accuracy: ± 50 ppm, ± 1 K Output: 0-10 V Output relay for alarms

9480-10C LAQUA Combined pH Electrode Long ToupH Glass Body (Large Containers and Long Test Tubes)

Electrodes

9480-10C LAQUA Combined pH Electrode Long ToupH Glass Body (Large Containers and Long...

HORIBA

9480-10C (3200611628)

This refillable pH electrode with integrated temperature sensor is ideal for testing samples in large containers and long test tubes (e.g., microbial culture fluids) due to its long, thin, glass-body.- Electrode: 283mm length, 8mm diameter- Constructed with responsive glass that is 10x stronger than JIS standards- Waterproof, Pb-free glass

View

SO-110 Soil Response Thermistor Reference Oxygen Sensor

SENSORS & PROBES

SO-110 Soil Response Thermistor Reference Oxygen Sensor

Apogee Instruments

SO-110

€495.00

TYPICAL APPLICATIONS• Measurement of O₂ in laboratory experiments or of O₂ gradients in soil/underground• Monitoring gaseous O₂ in indoor environments for climate control, in compost piles, and in mine tailings• Monitoring redox potential in soils• Determination of respiration rates through measurement of O₂ consumption in sealed chambers

INSIDE & OUTSIDE USE

HD2307.0 THERMOMETER for sensors Pt100/1000

SENSECA (Delta Ohm)

HD2307.0

View

SENSORS & PROBES

Thick Flexible Rogowski coil AO-FCT

AO-Electronics

AO-FCT

€40.00

The Rogowski coils must be connected to an electronic integrator for 90° phase shift compensation and frequency equalization: AO-S1 AO-D1 AO-S9

View

HF03-LI19 heat flux sensor commonly used in fire testing

HF03-LI19 heat flux sensor commonly used in fire testing 2

INSIDE & OUTSIDE USE

Portable heat flux sensor, with read-out unit / datalogger (HF03-LI19)

Hukseflux

HF03-LI19

HF03 is a heat flux sensor that is applied in mobile measurements. It is combined with LI19, a high accuracy handheld read-out unit / datalogger.The combination HF03- LI19 is typically used to study heat flux levels of flares and fires, and to verify the performance of permanently installed flare radiation monitors and flare heat flux sensors.

View

TAI-C Indoor Temperature Sensor (Out:RS485/Modbus) Nesa Srl

SENSORS & PROBES

TAI-C Indoor Temperature Sensor (Out:RS485/Modbus) Nesa Srl

Nesa srl

TAI-C

View

Radon Dosimetry with ON / OFF Dosimeter SKU: 510044

SENSORS & PROBES

Radon Dosimetry with ON / OFF Dosimeter SKU: 510044

RADONOVA

SKU: 510044

View

ODOS-5000 Sensor Óptico de Oxígeno Disuelto

ODOS-5000 Sensor Óptico de Oxígeno Disuelto 2

Oxígeno Disuelto DO

Sensor Óptico de Oxígeno Disuelto ODOS-5000

IKS-INDUSTRIAL

ODOS-5000

ODOS submersible version, applicable up to a water depth of 50m. First optical oxygen sensor with SCS interface! (Clark-Sensor Simulation) Seamless integration into running systems. The ideal replacement for your existing oxygen sensors. Model rangeThe sensor can be delivered with an IP68 termination plug or with a fixed cable in different lengths. For...

View

SMR07 Probe Conductivity Analyzer for Water Quality

SENSORS & PROBES

SMR07 Probe Conductivity Analyzer for Water Quality

Aquas Inc.

SMR07

IP68 conductivity analyzer (including temperrature compensation) (0~500ms/cm), POM housing, RS485 communication(3m cable)+Built-in temperaturesensor (Pt 100)(0~85℃)

View

INSIDE & OUTSIDE USE

MXGTW1 "MX Gateway" for Cloud Access Data

Onset

MXGTW1

€517.00

The new MX Gateway automatically transmits data from your HOBO MX Bluetooth Low Energy (BLE) data loggers, right to the cloud! Now you can use Onset's cloud-based HOBOlink software to remotely manage your data, set alarm notifications, and create custom dashboards. Saves time by reducing multiple site visits. You can download the HOBOconnect app here:

SENSORS & PROBES

Thermocouples Type "K" with 3m cable (4 units)

AO-Electronics

TC6-K(x4)

The Type "K" connector sensor cable allows deformation, without worrying about the risk of breakage or cracking.Includes K-Type Mini-Connector

View

DVE Precision Wind Vane Sensor with 0 ÷ 2Vdc, 4 ÷ 20mA or RS485/ModBus outputs

SENSORS & PROBES

DVE Precision Wind Vane Sensor with 0 ÷ 2Vdc, 4 ÷ 20mA or RS485/ModBus outputs

Nesa srl

DVE

Very High precision Wind Direction Sensor (better than 0.3°). According to standards WMO, EN 15518-3:2011

View