ST1R Temperature sensor - NTC

ST1R Temperature sensor - NTC

ST1R Temperature sensor - NTC

Reference: ST1R - Manufacturer: Wind Measure

Multipurpose ST1R temperature sensor has been designed for meteorological, industrial, agricultural or hydrological applications. Thanks to its waterproof housing made of 316L stainless steel and IP68 protection, the sensor is suitable for severe environmental conditions.

Sensor can be used with a radiation shield for long term ambient temperature monitoring or as an independent sensor for soli, liquid and many other measurements. It is compatible with all data loggers produced by Wind2measure, namely: BASIC, ADVANCED, VISIO and RADIO.

Technical Specification

Type	ST1R
Working temperature	-40 . +70°C
Accuracy at 25 °C	±0,5 °C
Sensing element	100kΩ NTC
Sensor dimension	ø6 x 60mm
Cable length	1 m
Ingress Protection	IP 67

DATA LOGGERS COMPATIBLE:

DATA LOGGER ADVANCED

DATA LOGGER ADVANCED

DATA LOGGER BASIC

DATA LOGGER BASIC

DATA LOGGER VISIO

DATA LOGGER VISIO

GP2 - Advanced Data Logger and Controller SDI-12 compatible

GP2 - Advanced Data Logger and...

€1,906.00

16 other products in the same category:

pH-33 LAQUATwin pH Meter (Calibration Points Up to 5)

pH-33 LAQUATwin pH Meter (Calibration Points Up to 5) 2

SENSORS & PROBES

pH-33 LAQUATwin pH Meter (Calibration Points Up to 5)

pH-33 (3999960124)

PH‐33, pH / temp, 5‐point calibration

3200611627 Combined pH Electrode Micro ToupH Glass Body 9418-10C (for Low Volume Samples) LAQUA

3200611627 Combined pH Electrode Micro ToupH Glass Body 9418-10C (for Low Volume Samples) LAQUA 2

Electrodes

9418-10C LAQUA Combined pH Electrode Micro ToupH with Glass Body (for Low Volume Samples)

9418-10C (3200611627)

This glass-body, refillable pH electrode can measure samples as low as 50µL.- Compatible with extremely small sample containers (e.g., microtubes)- Temperature sensor is placed beside the bulb for quick response- Waterproof

View

HD2004.30 Photovoltaic Panel

SENSORS & PROBES

HD2004.30 Photovoltaic Panel

SENSECA (Delta Ohm)

Monocrystalline 80W solar panels.

View

Master20T

Master20T 2

SENSORS & PROBES

Atago Master20T digital Handheld Refractometer

It is used to measure the sugar content in Brix degrees in fruit, fruit juices, soft drinks, etc.

SPL1 Support for Nesa rain gauges, 1000mm, ø 80mm

SENSORS & PROBES

SPL1 Support for Nesa rain gauges, 1000mm, ø 80mm

Support in anodized anticorodal aluminum for Nesa rain gauge, 1000mm, ø 80mm, useful height for ground mounting.Screws in stainless steel.

HOBOnet Water Level Sensor Interface

HOBOnet Water Level Sensor Interface 2

WATER (TEMP, LEVEL & QUALITY)

HOBOnet Water Level Sensor Interface

HOBOnet - RXW-WL-900

A wireless sensor interface that works with the HOBOnet system for remote water level monitoring. IMPORTANT INFORMATION A complete system requires at least one HOBOnet Water Level Sensor, a direct read cable, and a HOBO RX3000 Remote Monitoring Station and HOBOnet Wireless Manager (or a HOBO MicroRX Station with an integrated HOBOnet Wireless Manager)....

View

AQC11 - Soil Humidity and Temperature Probe

AQC11 - Soil Humidity and Temperature Probe 2

Soil Moisture

SDI-12 Portable Soil Humidity and Temperature Probe AquaCheck AQC11

SDI-12 Sub-Surface Probe with cable. The probes are available in sizes from 200 to 1600 mm and with from 2 to 15 sensors along the probe body. The AQC11 model is designed for permanent installation on the ground.

RXMOD-A1 4-channel Analog Module RX3000

RXMOD-A1 4-channel Analog Module RX3000 2

SENSORS & PROBES

RXMOD-A1 4-channel Analog Module for RX3000

These modules are mounted on the HOBO RX3000 to power sensors from other manufacturers. Each RX3000 supports one or two RXMOD modules.

SD-TEMP-xx Air/Water/Soil HOBO Temperature Sensor

SD-TEMP-xx Air/Water/Soil HOBO Temperature Sensor 2

SENSORS & PROBES

SD-TEMP-xx Air/Water/Soil HOBO Temperature Sensor

Self-Describing technology for quick, easy setup of the data logger Locking jack to ensure sensor is connected and stays connected Measurement range of -40° and 100°C (-40° to 212°F) Accuracy of ±0.15°C from 0° to 70°C (±0.27°F from 32° to 158°F) Available in lengths of 0.3 m (1 ft), 1.8 m (6 ft), 6.1 m, (20 ft) & 15.2 m (50 ft)

HOBO TidbiT MX External Temperature Logger

HOBO TidbiT MX External Temperature Logger 2

INSIDE & OUTSIDE USE

HOBO TidbiT MX External Temperature Logger

A waterproof data logger with both an internal sensor and an external sensor designed for monitoring fast-changing temperatures; can be deployed just above water or soil for the most convenient wireless data download to your mobile device or laptop.

View

Soil Humidity Sensor for Water content, Electrical Conductivity & Temperature

Soil Humidity Sensor for Water content, Electrical Conductivity & Temperature 2

ENVIRONMENTAL PRODUCTS

WET-2 Soil Humidity Sensor - (Water content, Electrical Conductivity & Temperature...

Wet Sensor WET-2 for soil humidity - (Water content, EC and Temperature). Includes 1m cable fitted with 25-way D socket, suitable for connection to HH2.

S-SO2 European Gas Sensor for measurement of SO2 Sulfur dioxide (100ppm)

S-SO2 European Gas Sensor for measurement of SO2 Sulfur dioxide (100ppm) 2

Air quality

S-SO2 European Gas Sensor for measurement of SO2 Sulfur dioxide (100ppm)

S-SO2 "

AO-KWD Precision Wind Vane

SENSORS & PROBES

AO-KWD Precision Wind Vane

LP 35 PHOT Photometric Probe for Measuring Illuminance

INSIDE & OUTSIDE USE

LP 35 PHOT Photometric Probe for Measuring Illuminance

SENSECA (Delta Ohm)

Photometric probe for measuring illuminance, CIE photopic filter, spectral response according to the standard photopic curve, diffuser for cosine correction. Measuring range: 0.1 ... 200,000 lux. Cable length 5 m M12 connector.

View

SDI-TRANS-USB, SDI-12 to USB Protocol Translator

SDI-TRANS-USB, SDI-12 to USB Protocol Translator 2

SENSORS & PROBES

SDI-TRANS-USB, SDI-12 to USB Protocol Translator

Replace your expensive data logger, and turn your PC into an affordable SDI data logger with the SDI-12 to USB Protocol Translator board.Plug in the board into a USB port, open Windows HyperTerminal, and you are ready to query SDI-12 compliant sensors.

P3 Protection for probes

P3 Protection for probes 2

SENSORS & PROBES

P3 Protection for probes

SENSECA (Delta Ohm)

View

Product added to wishlist

Product added to compare.

We use our own and third-party cookies to improve the browsing experience and offer content of interest. By continuing to browse we understand that you accept our Cookie Policies.

Allow