AO-FS1051 Temperature transducer with surface sensor (-40 to + 400°C), Modbus RTU output

The FS1051 surface transducer with stainless steel block registers the temperature on surfaces and converts this measured value into a digital output signal.
Using a screw or mounting glue the stainless steel block of the temperature sensor is quickly and securely mounted to the surface to be measured.
As special equipment a potential-free alternating contact and / or a backlit display are available The contents of the display can be rotated in steps of 90 ° by using a command.
As special functions a series of defined measured values ​​from other bus-participants (also cross-manufacturers) can be shown in the display. To display measured values ​​from other bus-participants these are entered into the corresponding register by the bus-Master. The optional alternating contact can be configured for measured values ​​from other bus-participants.
The configuration of address, transmission mode / speed, terminating resistor and master / slave function of the bus-devices can easily be done using the innovative DIP switch technology. Thus devices can quickly and easily integrated into the system and later parameterized via the master.
The bus-devices can even be reset to the works settings during operation of the master. Thus the basic functionality of the device is recreated in a matter of seconds. This can be necessary in the event of incorrect parameterisations of, e.g. offset, switching threshold, display modes etc ..
By means of the FS master / slave topology autarkic nodes without additional SPS master can be installed within the device series. Hereby a bus-device assumes the master function in the node. This requests the measured values ​​from other bus-participants, automatically enters these into the corresponding register and shows them in the internal display. Furthermore the master can evaluate and operate additional actuators in the device series (analogue in- and outputs, relay station).